Distributor Gear

Distributor Gear”

When a car starts to fail or be difficult to start, several potential problems come to mind. Is it the battery? Jumping fuel line? If the faulty spark plugs? In fact, the ignition module can be broken, a problem often neglected and poorly understood. For most drivers, the best solution is to take your car in a garage repair attempted by a mechanic.

Its modulus Ignition Operation

Basically, an ignition module is a device that transfers a signal from the distributor to the ignition coil when the key is turned, essentially acts as a mediator.

A distributor is a device that rotates the firing of the law to plug ignition candles, passing on the tension generated by the ignition coil. Assembly consists of an insulating rotor mounted inside the cap distributor, the rotor is rotated by a gear camshaft, so that synchronization with the movement of the engine.

Ignition Coil is an induction coil that raises the standard output of 12 V car battery to the order of several thousands of volts required by the candles. Depending on the type of car you drive, a coil can serve several cylinders, which increases the overall reliability.

simple diagnostic

To accurately determine if the module is at fault, it is necessary to test in advance. For the mechanic "do it yourself, there are several tools available on the market for the ignition module test. However, these devices can be very costly, not to mention intimidation novice mechanic.

As indicated above, the best solution is to have the vehicle inspected by a certified mechanic. Not only the mechanic to determine if the module performs poorly, but may point to other possible issues in the case of a conclusive diagnosis.

Replacement procedure

If the module is be replaced, several tools are needed. You need bright overhead lighting, rags, pliers, wrenches, screwdrivers, and service of or the vehicle owner's manual. The first step to remove the old installation is to disconnect the battery. Then, locate the drive with the manual, remove the screws and unplugging cables.

Then remove the parts that prevent access to the module and carefully set aside so you can easily replace later. After this step, remove the brackets and screws, and remove the old assembly.

To install the new engine, just repeat the process Conversely disposal: assemble brackets and screws, reinstall the parts adjacent, and then reconnect the device the electrical system. After all the tools and parts are clearly lost, reconnect battery and start the engine to test your work.

The value of a mechanical

Indeed, the process of replacing this part is not complicated. sufficient attention to detail, most people who took a lesser job importance in their vehicle can perform the removal and installation without any problems. That said, if you do never worked in his car, or are uncomfortable about how to work, have a trained auto do it for you.

For all your used auto parts and used transmissions needs consider the leader in parts, http://www.everdrive.com